+86-0576- 84628991
  • The difference between printer and printer

      The printer is a kind of equipment that is controlled by software and uses non-contact method to mark on the product. According to the difference of the working principle of the printer, the jet machine can be divided into continuous jet print...

  • What is the IML system

    The plastic molding machine, referred to as the press or press, is the main equipment for thermosetting plastic molding, and is a machine that applies pressure to the lamination. The earliest used presses were hand-type, and have been eliminated due ...

  • Advantages and disadvantages of the IML process

    I. The concept of IML IMD (In-Mold Decoration) is a new technology for placing a Film film in an injection mold to decorate the surface of a plastic surface. At present, IMD has two manufacturing methods. One is to make a printed Film film into a cir...

  • What is the principle of IML compression molding

    The rheological behavior of thermosetting plastics in compression molding is much more complicated than that of thermoplastics. The entire molding process is always accompanied by chemical reactions. The materials in the initial stage of heating are ...

  • IML technology can realize injection molding

    The development prospect of IML process   At present, IML in-mold decorative inlay molding technology is widely used in communications, home appliances, electronics, automobiles, instruments, instruments, medical devices, toys, cosmetics and other in...

  • What are the disadvantages of IML system

    1. The production cycle is longer than injection molding and injection molding, and the production efficiency is low, especially for thick-walled parts. 2. There are often thick flash edges on the parts, and the thickness of each die edge is differen...

  • What is the injection molding technology of IML

    The injection molding skill of IML is to put the silk-printed and hot-pressed PET film into the injection mold. After the injection process of ABS material, the PET film can be pressure-molded with the ABS material in the cavity of the injection mold...

  • How to prevent label machine ribbon breakage

    First, what causes the label machine ribbon to break? How to avoid breaking? 1, the casing material will also cause broken belts - there are a variety of PVC casing materials sold in the market, customers blindly to buy it is prone to such problems, ...